Hooking Up Your Stereo to Your PC or Laptop - dummies
- Be sure that your stereo has some type of input in the back.
- This way, you can be sure that you can always listen to your favorite music or use your phone hands-free whenever you are driving.
- An audio auxiliary cable is a type of cord connector that has an audio jack on each end that lets you connect any music-playing gadget to any electronic device that has an auxiliary port.
- Most aftermarket stereos today have either an attached dock connector, or a dock connector available.
If you have component speakers, and therefore a crossover, make sure the crossover is secured in the speaker compartment so that it does not bounce around while you drive. Though the analog audio is passable, it isn't the best. Enable Bluetooth on your iPhone. These are the head unit, the main speakers, optional amplifiers and the subwoofers, which are also optional but generally considered a necessary part of any good system.
Share your voice
Tune your car stereo to cassette, and you're ready to go any cassette adapter at those stores should work with the iPod, so don't get suckered into buying the most expensive name brand. Once you've done this, europe dating site 100 free drill your hole. The exact name or mode will vary based on your model of car.
Then slide your head unit into its slot in the dash and screw it securely in place. Get real help from an expert like Marisa Contact us. Do this one at a time or use masking tape to label the wire to avoid confusion. It never occurred to me that I'd be lucky enough to keep on doing it for a living. If they must cross do so perpendicularly and only in one spot.
How to Connect iOS or Android Devices to Stereo Systems
Enter the passcode to connect. This is extremely important since you do not want to realize you're missing something in the middle of the installation. Blowing a speaker due to misuse is not only irritating but expensive. Check all speakers and make sure they are properly wired. Similar devices like Blu-ray players and home video-game consoles can be added in the same basic way.
Hook up the stereo receiver to the speakers. Once you've done this, turn on the receiver and whatever else you wish and take your newly hooked-up home stereo system for a test drive. Hook up the television to the receiver.
Then put the dash back on. This article was written by the It Still Works team, copy edited and fact checked through a multi-point auditing system, in efforts to ensure our readers only receive the best information. Generally if you are installing a new head unit you want to install new speakers. Replace your stereo and dash. Audiophiles will definitely notice.
Connect a Smartphone to Your Car Stereo
If the speaker wires are separate from the harness connect them using the method of stripping, twisting, and taping described above. For maximum audio, a digital optical cable is a valid option. Many cars today have the option of being equipped with an iPod or digital music player connection.
Find a good screw or bolt, take if off and sandpaper the metal surface that the o-ring will make contact with, belize dating then screw it down tightly. Follow the instructions you got for removing whatever part of the dash covers it and take out your existing head unit. Already answered Not a question Bad question Other.
You may be able to find a guide for this online. Connect the cable to your iPhone's headphone jack and the auxiliary port on the stereo. Usually, one is red, one is white, and they may or may not be covered by small rubber caps depending on how old it is. Disconnect the ground negative cable from your battery first and foremost.
Bend the twists so they are in-line with the wire and wrap each connection in electrical tape so no wire is showing to protect them. Welcome back Looking for wireless Bluetooth headphones? Wire strippers Amplifier wiring kit Electrical tape. Ideally the speaker wire will be connected to the old speakers with a metal clip that can then slide right on to your new ones.
Your speakers should have come with their own speaker wires. To submit your questions or ideas, or to simply learn more about It Still Works, contact us. These can be purchased at any major electronics retailer, like Best Buy. Users are able to browse their files from the dashboard, which is less distracting not to mention legal in all states and utilize systems, such as Ford's Sync for voice command, if present. At the least, you'll need some red, white and yellow component cables.
How to Connect iOS or Android Devices to Stereo Systems
Please visit our Support page to find the help you need. Please keep your phone line open. Connect the other end of the auxiliary cable to the headphone jack on your iPhone.
His articles have appeared on a variety of websites. Swipe up from the bottom of the screen and tap the Bluetooth button to turn it on. Screw the speaker in place. When do you want us to call you back?
- We have encountered a problem.
- Learn about Crutchfield Rewards.
- Here's how to find out which model may be right for you.
- Wait to put the speaker enclosures back together until you have installed the head unit.
How to Wire a Car Stereo System
How to Hook your iPhone up to your car stereo Smartphones Gadget Hacks
Tips Guides to purchasing all of the above mentioned components can be found right here on eHow. This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. If you are having trouble figuring out which wires go to which speaker or which is positive and negative read the tip at the bottom of this section. Decide where you will be putting your iPod and where you want the wire going. This is really handy for tuning the sound.
Shop our latest specials Open promo. Start Bluetooth Pairing Mode on your car stereo. Press play on your iPhone or on any other controls your car may be equipped with for controlling the stereo. With only one cable to connect and no software to contend with, this is the easiest way to use your Android phone in the car.
The Tech Guy
Since that time, several options have become available that enable you to play your iPhone's digital music through your car speakers. If your infotainment center supports CarPlay, tap or select the CarPlay option that appears on the menu after connecting your iPhone. Select your car stereo in the list of Bluetooth devices on your iPhone. Take the other end of the cable and plug it to the auxiliary port on the car stereo.
Do not put your new head unit into the dash yet-you still need to connect the amplifier to it. You can damage yourself and your equipment. And as the technologies within both phones and stereos and the ways to connect them continue to evolve, it's a topic we do our best to stay on top of. Connect with an Advisor Open promo.